This is the brain of your 3D printer.
The Azteeg X3 is a full featured, easy to use 3D printer Electronics powered by the reliable and powerful Atmel ATMEGA2560 micro controller.The X3 is designed with excellent high current capability to run most 3D printer...
Azteeg X5 GT
The X5 GT is a 32 bit ARM based Motion controller for 3D printers, CNC Machines and Laser cutters. The X5 GT runs on Smoothieware firmware and is based on Smoothieboard. The X5 GT uses the powerful 32bit, 120Mhz...
Azteeg X5 Mini V3
The X5 mini V3 is a 32 bit ARM based Motion controller for 3D printers, CNC Machines and Laser cutters. The X5 mini runs on Smoothieware firmware and is based on Smoothieboard. The X5 mini uses the powerful 32bit,...
Heated Beds for 3D Printers
A heated bed will allow prints to contract slower and adhere better to substrates that have an adhesive on them such as glue sticks or hair spray. When printing with ABS and most engineered filament, a heated bed is...
Micro SD card adapter for RAMPS
This fun little adapter is for those that do not want to add an LCD but want an onboard memory for the RAMPS 1.4. Specifications: Up to 50MB/s data transfer SPI mode supply voltage 4...
MKS Base V1.2 3D Printer controller
Tired of that double stack RAMPS and MEGA controller?
Enter the MKS Base 1.2. This board will give you all the comforts you are used to in Marlin with the RAMPS board while reducing the bulk the controller takes up...
PT100 Amplifier Board
This amplifier will allow a sensing range of up-to and beyond 400C, the maximum safe working temperature of an all metal hotend. Truly amazing. Extrude materials that require a higher temperature as well as get a more...
RAMPS 1.4 Kit
If a power supply is the heart of your 3D printer, this would be the brain. Included in the package: 1 qty RAMPS 1.4 board completely soldered 5 qty A4988 stepper sticks completely soldered 15 qty jumpers (for setting...
RAMPS wiring kit
The RAMPS wiring kit comes with 9 wiring harnesses that are 24 gauge wire, 70cm long per lead: 2 x 2 pole (one hotend thermistor, one bed thermistor) 3 x 3 pole (three endstops) 4 x 4 pole (four stepper motors) The kit...
RE-ARM is a 100Mhz, 32-bit ARM controller with the popular Arduino MEGA footprint. It's a plug-in replacement for the Arduino Mega in your RAMPS setup for a quick and easy upgrade to 32-bit.
Have more steppers than the typical board can handle? Rumba to the rescue. An ATmega's AVR driven board, using the Arduino IDE to set firmware just like a RAMPS stack.
5 interfaces for temp sensors
Smoothieboard is an all in one board for digital fabrication machines. It is made to be used for 3D printers (Reprap) CNC machines, and laser cutters. This board has so many uses and arrives at your doorstep pre-flashed and...
All prices are in USD. © 2017 SMW3D | Sitemap