Account Navigation

Account Navigation

Currency - All prices are in AUD

Currency - All prices are in AUD
 Loading... Please wait...
  • Call us on 346-333-6500
  • My Account
  • Gift Certificates
SMW3D

CO2 laser tube

$239.99

CO2 laser tube

$239.99

Other Options

Share

Product Description

Caution: Use of a laser, regardless of power, can be extremely dangerous. Never use a laser where the beam is not fully enclosed from start to final engraving position. Never use a laser without proper safety latches installed. The laser can reflect off of materials and cause serious injury to persons or property. This power laser can easily create a fire, never leave unattended while powered on. Always use proper safety gear prior to powering on the laser. Please research before using this product about laser safety and understand the risk prior to purchase. SMW3D assumes no responsibility for any damage caused by the misuse of this product. 

Description:

A quality, tested, class 4 laser tube for your laser build. 

The tube is made by SPT. SPT enforces high quality standards and manufacturing processes such as lens testing, catalytic coating of resonant cavity, and highly precise gas filling process. 

These tubes do require a water pump at the minimum, a chiller  is advised above the 35w tube. Water should be ran through the tube for a full 24 hours after install to remove as many air bubbles from the system as possible. 

To install the tube, connect the leads from the power supply, then connect water inlet and outlet. Run water through the tube for 24 hours. One can now adjust  mirrors and the tube ready for use. 

40W

Specs:

The tube is 700mm long and 50mm in diameter.

Glass construction with a sealed metal cap.

Wired and ready to use.

Rated power 40W

Peak power 50W

Lifetime hours 4000

Manufacturers warranty 3 months

Test mA 15

Net weight 1.12Kg

Stability 5%

Beam divergence angle 3.1mrad

Wavelength 10.6um 

 

50W

Length 1000mm Diameter 50mm

Glass construction with a sealed metal cap.

Wired and ready to use.

Rated power 50W

Peak 55W

Trigger Voltage 20Kv

Lifetime hours 2000

 

60W

12mm length, 50mm diameter

Glass construction with a sealed metal cap.

Wired and ready to use.

Rated power 60W

Peak power 65W

Lifetime hours 2000

Trigger voltage 25Kv

 

Caution: Use of a laser, regardless of power, can be extremely dangerous. Never use a laser where the beam is not fully enclosed from start to final engraving position. The laser can reflect off of materials and cause serious injury to persons or property. 

 

Find Similar Products by Tag

Product Reviews

Write Review

This product hasn't received any reviews yet. Be the first to review this product!

Find Similar Products by Category